Zaxcom Nomad Manuel d'utilisateur télécharger pdf (Page 64)

NOMAD OPERATIONS Bus Key

Pressing the Bus Key

Output Bus Assign Busses

The output bus matrix lets you assign your analog and digital inputs to your output buses.

To move between the matrixes, press the BUS Key.

The top line of the three pages indicates the following sources:

• Analog Inputs 1-6

• R1, R2, R3, R4 = TA5 Inputs (Camera Returns / Line input 7-10)

• Digital Inputs 1-8 – when the digital input is in RED

• S = Slate

• C = Com

• T =Tone

Please note that when the Input is in RED that means that the input is unavailable. To make it available you need

to go to the input configure menu to change the selection number.

Setting a Cross-Point

Rotate the MENU knob to scroll through the matrix. Stop in the matrix, at the intersection of the input channel

and output bus, where you want to send that specific input. Press the MENU knob to cycle through the available

cross points, which are:

• X – The input will be sent to the output bus post-fader.

• P – The input will be sent to the output bus pre-fader.

• X – The input will be sent to the output bus post-fader with phase inverted.

• P – The input will be sent to the output bus pre-fader with phase inverted.

To add the optional phase invert, while you are in this matrix press the STAR key. Then by pressing the

MENU knob, you will now be able to cycle through the selections with phase invert.

Power cycling the unit will reset it to no inversion mode but will keep your phase invert choice.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 89 90

Pas de commentaire

Zaxcom Nomad Manuel d'utilisateur Page 64